Displays the available assignment categories for either the project defaults and Compiler settings, or for specific entity and node settings. The available assignment categories vary depending on whether you select Edit project defaults & Compiler settings or Edit specific entity & node settings for under Mode. You can choose from the following assignment categories:
| Assignment Category |
Device Family Support |
| Locations |
All Altera® devices supported by the Quartus® II software |
| Timing |
All Altera devices supported by the Quartus II software |
| Cliques |
ACEX® 1K, APEX™ 20K, APEX™ II, ARM®-based Excalibur™, FLEX® 6000, FLEX 10KE, and Mercury™ devices |
| I/O Standard |
APEX 20K, APEX II, ARM-based Excalibur, MAX® 7000B, Cyclone™, Mercury, Stratix™, and Stratix™ GX devices |
| Local Routing |
APEX 20K, APEX II, ARM-based Excalibur, and FLEX 6000 devices |
| Options for Individual Nodes Only |
All Altera devices supported by the Quartus II software |
| Options for Individual Nodes & Entities |
All Altera devices supported by the Quartus II software |
| Options for Entities Only |
All Altera devices supported by the Quartus II software |
| Parameters |
All Altera devices supported by the Quartus II software |
| Simulation |
All Altera devices supported by the Quartus II software |
| LogicLock™ Regions |
APEX 20K, APEX II, ARM-based Excalibur, Cyclone, Mercury, Stratix, and Stratix GX devices |
| HardCopy™ Timing |
APEX 20K and APEX II devices |
